How to install a Tailgate Seal with Taper Seal®

ITEMS REQUIRED: Scissors, clean rag and soap solution.
Extreme temperatures will result in poor adhesive performance. Apply only if air and surface temperature is between 55° - 105°F (13° - 40°C). Avoid touching adhesive after peeling off red liner.

Repositioning of seal should not be done more than 3 times and only once if the temperature is above 80°F (13°C)

Click on photo for an enlarged view

2016 GMC Canyon

Clean area thoroughly with soap and water solution and wipe completely dry. Use alcohol pad to prep the tape application area and let dry. Wait until after Tailgate Seal is installed before applying very firm pressure, to secure adhesive bond. If necessary, Tailgate Seal can be removed and repositioned prior to applying very firm pressure. Pictures shown below are for the left sidewall and tailgate gap.

Start 1” below truck bed floor and attach seal to the rear corner edge of the left sidewall extension (FIG 1A). When nearing top of sidewall, gradually rotate seal 90° counter clockwise so that bulb is facing inward and the taped side of seal is flush with the sidewall at the top (FIG 1B). Apply light pressure to adhesive. Duplicate for the right sidewall.
Cut and attach a 3" piece just below the top of bedrail. Flush to the seal on the sidewall extension, bulb side facing outwards. Apply light pressure to adhesive. Duplicate for the right sidewall.
Alternate view
Start at either end of the tailgate gap and flush with Tailgate Seal on the sidewall. For this application the hinges, near the sidewalls, make the width of the tailgate gap smaller for the first 4" to 5". Simply invert seal so that bulb side is down. Cut a piece and attach, apply light pressure to adhesive. Duplicate for the right side of tailgate gap.

Continue attaching seal, bulb side up, to the tailgate gap. Align seal just below the lower ridge of truck bed floor. Peel back liner and attach in sections, applying light pressure to adhesive. When flush with inverted seal on the right side cut to fit.

Alternate view

Cut and attach a 3.750" piece to the side of tailgate, near the top, bulb side facing left. Cut and attach a .750" piece and position as shown in picture. Apply only light pressure to adhesive. Duplicate for the right side.

Alternate View
Close tailgate. If you see light through the sidewalls, make adjustments by removing the seal and repositioning. If there is still light then cut pieces of seal, as needed and attach to sidewalls and/or tailgate. Do not attach adhesive to seal. After Tailgate Seal is in place, apply very firm pressure to secure the adhesive bond.
Inside view showing left side of tailgate when closed
Due to the variety of truck designs the application of Tailgate Seal with Taper Seal® may vary slightly.
       Taper Seal® is a registered trademark of Extruded Solutions, Inc.
	   U.S. Patent #10,099,544